Fuse Replacement:
Unplug the IEC power cable before replacing the fuse! Always replace with same type of fuse.
1. Using a flat head screwdriver, remove the fuse holder from the IEC housing.
2. Remove the bad fuse from the fuse holder.
3. Insert the new fuse into the fuse holder.
4. Install the fuse holder in the IEC housing.
Mounting orientation:
This fixture should only be mounted/used on a flat surface. This fixture should not be tilted.
General maintenance
To maintain optimum performance and minimise wear, the item should be cleaned frequently. Usage and environment are
contributing factors in determining the cleaning frequency. As a general rule, fixtures should be cleaned after use to avoid dust build-
up and blockages, which can result in poor performance, overheating and breakages. Be sure to uplug the unit from the mains
before
conducting any maintenance. Use a vacuum and a soft brush to remove dust collected on external vents and internal
components. Clean the external case when the unit has
completely
cooled down with a dry cloth or tissue.
Regular maintenance
Be sure to power off fixture
before
conducting any maintenance. Every 40 hours of continuous operation, it is recommended to run a
cleaning solution
composed of 80%
distilled
water and 20% distilled
white vinegar
through the system to prevent the
accumulation of particulate matter in the heating element.
The recommended cleaning regime is as follows:
1. Empty all haze fluid from the machine.
2. Add the above
cleaning solution
to the tank (80%
distilled
water and 20% distilled
white vinegar
).
3. Plug the unit in to the mains and allow it to warm up.
4. Run the unit in a well-ventilated area until the tank is almost empty.
Do not allow the pump to run dry.
Cleaning is now complete. Refill with haze/smoke fluid. Run the unit briefly to clear any cleaning solution from the system.
Trouble shooting
Symptom
Solution
No Power
Check mains power.
Check external fuse.
No haze output
Check fluid level.
Check that there is no blockage in the system.
Breaker/fuse keeps blowing
Possible electrical short. Contact retailer/distributor for further instructions.
Low haze output
Run a cleaning solution through the unit.
Check that the unit is plugged into the correct voltage.
Haze machine is not heating up
Check the external fuse.
Possible faulty part. Contact your retailer/distributor for further instructions.
Remote control does not work
Make sure connector is firmly connected to device.
Try using another controller.
Possible faulty controller.
Check the external fuse.
Specifications and features
Model
Kam KHM400
Power supply
230V AC - 50Hz
Power
600w
Re-heat time
3-4 minutes
Output
2,500 CuFt per minute (approx)
Tank capacity
2.3 litres
Manual haze button
Yes
Remote control
Wired
Weight
5.3kg
