AUTO
Auto cycles the built-in programs without being controlled externally. It has no laser off.
Refer to chart above to set desired auto mode
DMX Control
The system only accepts the DMX512 signal of international standard to control the system. The laser
beam ON /OFF, laser pattern selection, running direction, beam speed and colour selection etc.
DMX Control Parameter Chart
Channel
Function
Value
Description
CH1
Mode
0-69
Black out
70-139
Sound active mode
140-209
AUTO mode
210-255
DMX mode
CH2
Pattern selection
0-255
Pattern for selection
CH3
Flashing speed
0-255
Laser flashing
CH4
Beam effect
0-255
Beam effect for selection
CH5
This channel has no effect on the laser and is not used
CH6
Position-X
0-255
Adjust position-X
CH7
Position-Y
0-255
Adjust position-Y
CH8
Pattern size
0-255
0 is small, 255 is big
CH9
Colour selection
0-255
R, G, Y, 3 colours combined
DMX address calculation
For DMX mode, DMX address dipswitches from 1 to 9 must be set; the address is set from 1 to 511. Each
dipswitch represents a binary value.
Dipswitch
Value
Dipswitch
Value
# 1
1
# 6
32
# 2
2
# 7
64
# 3
4
# 8
128
# 4
8
# 9
256
# 5
16
# 10
DMX, Set to “0”
One unit has 9 channels, so each unit must be assigned at least 9 channels.
When setting dmx address and dmx chains
OPERATION
Stand-Alone Operation
Sound mode
This mode allows a single unit to react to the beat of the music
1. Install the units in a suitable position
2. Set dipswitch to select Sound Active or AUTO mode.
3. Turn on the unit power, the unit begins reset, then the unit begins working.
4. The unit will react to the low frequencies of music via the internal microphone.
Adjust the audio sensitivity knob on the back of the unit to make the unit more or less sensitive in sound
active. The panel has LED flashing for sound active.
Universal DMX Operation (DMX mode)
This mode allows you to use universal DMX-512 controller
1. Install the units in a suitable position