Kaltenbach KPS 501, Руководство пользователя

Страница: 109 / 268

KPS SERIES
Technical Documentation
M-UK-KPS--06
11/02/03 Page 109 of 138
KALTENBACH
6.2 Tools
6.2.1
Punch and Dies General Information
CAUTION
Wrong Punch Tool Settings can inflict grievous bodily harm to
persons.
The diameter of the punch hole should always be bigger than
the material thickness to be processed !
•
With all types of punch units, except the triple-unit (KPS503/ KPSA206), an
hole-in-hole can be punched, only if ¾ of the punch punches in full material.
For the triple-unit only the punch in the middle is allowed to punch hole-in-hole.
The outer most punches are not allowed to punch hole-in-hole.
•
To reduce deforming of the material, a distance of at least 1 hole diameter of
the edge should be observed.
• To reduce deforming of the material, a distance of at least 1 hole diameter
should be observed between each hole.
•
Use the right ‘family’ of punching tools for the vertical and flange punch. See
the supplies:
Drawing # 700055 Tool information & min punch position KPS503
•
Pay attention to using the right (special) tools for the flange punch if processing
angle steel and/or U-profile. Consult your dealer or tool supplier.