Kalor QUADRA 12D, Руководство пользователя

Страница: 28 / 36

58
EN
Any inconvenience and solutions
Given that all stoves are tested in their parts handling and work and therefore are delivered in perfect physical condition
and operation, it should be remembered that the transport, unloading, handling, misuse or poor maintenance, can be
causes of drawbacks.
The main problems may be solved by reading the table below.
If after doing as hereinafter described the problem is not resolved, contact your authorized service center.
Problems and solutions
All repairs must be carried out exclusively by a specialised technician, with the
stove completely cold and the electric plug pulled out. Is prohibited from any
unauthorized modification to the device and the replacement of parts with
other non-original. The operations marked in bold type must be carried out by
specialised personnel.
PROBLEM POSSIBLE CAUSE REMEDY
Display off and buttons
are not working
1. Power failure in the network
2. Switch back off
3. Display defective
4. Fault in the connection of the
display with the card
5. Fuse board interrupted
6. Card defective
1. Check that the power cord is connected
2. Use the switch back to operate it
3. Unplug the stove from the power outlet for about
one minute and then turn on. If the problem persists,
contact an authorized service center
4. Check that the display and board are properly con-
nected. Contact your authorized service center
5. Contact an authorized service center
6. Contact an authorized service center
Remote inefficient
1. Too far from the stove
2. No batteries in the remote
3. The remote control is broken 1. Move closer to the stove
2. Check and change the batteries
3. Replace the remote control
Failure to ignite
the stove
1. Excessive accumulation of ash
in the grate
2. Incorrect ignition procedure
1. Clean the grate
2. Repeat the ignition procedure.
I
f the problem per-
sists, contact your authorized service center
Smoke comes from the
grill
1. Accidental electrical blackout
1. In case of ignition phase interrupted and momen-
tary interruption of the fan, can occur slight amount of
smoke
Hot air fan is not work-
ing 1. The stove has not yet been
heated
1. Wait until the conclusion of the ignition cycle.
Arrived in temperature, the fan will start automatically.
If the problem persists, contact your authorized service
center.