53
GB
The stove is clogged
early in the brazier
with burning irregular,
door glass gets dirty,
the flame is long, red-
dish and weak
1. Flue with presence of stretch-
es too long or clogged
2. Too pellet
3. Excessive pellet or ash depos-
its in the brazier
4. The brazier is not found in its
slot
5. Wind contrary to the exhaust
flow
6. Insufficient combustion air
7. You changed the type of pel-
lets used
8. Smoke extractor motor broken
9. Door closed incorrectly
1. Perform periodic cleaning. See paragraph stove
installation in the user manual. Check chimney
cleaning
2. Decrease in the parameters the charge level of the
pellets
3. Clean the brazier after waiting for the total shut-
down of the stove.
If you repeat contact your
Authorized Service Center
4. Check that the hole in the brazier matches the
glow plug
5. Check the chimney cap windproof and / or pos-
sibly install it
6. Check the correct position of the brazier, its clean-
liness and check that the air intake in both free envi-
ronment, verify the status of the door seal, increase
the level in the parameter relative to the speed of
the fan exhaust fumes.
Contact your Authorized
Service Center
7. Check the quality of the pellets.
Contact your
Authorized Service Center
8. Increase the level in the parameters relating to the
speed of the fan exhaust fumes.
Check and eventu-
ally replace motor
9. Check that the glass is sealed and the seal guar-
antees tightness
Smell of smoke in the
environment. Turning
off the stove.
1. Poor combustion
2. Malfunction of fan fumes
3. Installation of the flue per-
formed incorrectly
4. Clogged chimney
1. Contact your Authorized Service Center
2. Contact your Authorized Service Center
3. Contact your Authorized Service Center
4. Contact your Authorized Service Center
In the automatic posi-
tion the stove always
runs at full power
1. Room thermostat set to maxi-
mum
2. Significant temperature sensor
failure
3. Control panel defective or
broken
1. Reset the thermostat temperature
2. Check the operation of the sensor and replace if
necessary
3. Check the control panel and replace if necessary
The engine smoke
extraction does not
work
1. The stove has no voltage
2. The motor is broken
3. The board is defective
4. The control panel has failed
1. Check the supply voltage and the protection fuse.
2. Check the motor and capacitor and replace if
necessary.
3. Replace the circuit board.
4. Replace the control panel.
Содержание Denia 14
Страница 1: ...INSTALLER USER MANUAL For Denia 14 14D Mia 16 16D...
Страница 28: ...55 GB NOTES...
Страница 29: ...56 GB NOTES...