background image

INSTALLATION INSTRUCTIONS

Toilet

1142313_2_A

8 of 9

Questions? Problems? For additional assistance, please contact KALLISTA’s Customer

Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.

TROUbLEShOOTINg gUIdE

SYmPTOmS

Recommended Action

Poor flush.

1.  

Adjust the tank water level to match the waterline.

A.  

Fully open the water supply shut-off valve.

B.  

Clear obstructions from the trapway, jet, or bowl rim holes.

C.  

Clear obstructions in the soil pipe or vent pipe.

D.  

Remove the tank lid, loosen the locknuts on the push button assembly and unscrew the push button rods 

E.  

slightly to lengthen them. Replace the tank lid and flush. Repeat adjustment until the flush is acceptable, 

tighten the locknut.

No flush.

2.  

Make sure the push button rods are in place. Adjust as needed, following the directions in step E. above.

A.  

The fill valve turns 

3.  

on/off by itself with-

out the toilet being 

flushed, or it runs 

allowing water to 

enter the tank.

Remove the tank lid, loosen the locknuts on the push button assembly and screw in the push button rods 

A.  

slightly to shorten them. Replace the tank lid and flush. Repeat adjustment until the flush is acceptable, tighten 

the locknut.

Clean or replace the flush valve seal if it is worn, dirty, or misaligned with the valve seat or flush valve seat is 

B.  

damaged.

Remove the tank and tighten the flush valve nut if flush valve gasket is leaking. Do not overtighten. If leakage 

C.  

continues replace the gasket.

Clean the fill valve seat/seat washer of debris or replace the piston/seat washer assembly.

D.  

Replace the fill valve if the valve float sinks.

E.  

Adjust the tank water level if it is too high.

F.  

Long tank fill cycle.

4.  

Fully open the water supply shut-off valve.

A.  

Clean the valve inlet, valve head, or supply line. Flush the lines.

B.  

Noisy tank fill cycle.

5.  

Partially close the water supply shut-off valve if the water pressure to the toilet is too high. Check the toilet 

A.  

performance following any such adjustment.

Remove dirt or obstructions from the valve head. Flush the lines.

B.  

Содержание P70310










Отзывы: