INSTALLATION INSTRUCTIONS
One™ Console Table
1110776_2_A
4 of 6
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
INSTALL THe BeNT TUBe ASSeMBLY
3.
Table Leg
Assembly
Bent Tube
Assembly
Height Adjustment
Peg
O-rings
NOTe: Moistening O-rings with a drop of water will help with installation.
Use only water.
Make sure the height adjustment pegs are turned all the way into the
table leg assemblies and the O-rings are on top of the leg assemblies.
Set the leg and towel bar assembly into the holes in the floor.
Push the bent tube assembly onto the leg and towel bar assembly.
MOUNT TABLe LeGS TO wALL
4.
Bent Tube
Assembly
Height Adjustment
Peg
Lean assembly against the wall and verify that the legs are plumb and
the top of the bent tube assembly is level front to back and side to side.
Adjust the height adjustment pegs as necessary.
Mark the location of the mounting holes on the wall.
Remove the assembly and drill the wall holes.
Replace the assembly and attach it to the wall.