Kalley K-LED43FHDST2, Руководство по обслуживанию

Страница: 16 / 41

8 / 13
Hotel menu
4
、
Service Menu
1
、
Methods of Entering
Using the remote, enter the
“
Picture
”
submenu in the OSD; choosing the
“
contrast
”
item and press the 9,7,0 and 5 in series, Service Menu will appear in
the left top of screen
SERVICE MENU
：
ITEM Defau
lt
Setti
ng Description Status
1-Factory hotkey Off
Factory hotkey Switch (OFF/ON).Should be OFF
after factory alignment OK
2-WARM-UP Off
OFF
：
The set would enter standby mode after 15
minutes without input signal
；
ON
：
Aging mode. Aging time will display on the
left bottom of screen.
NOTE: Enter and exit the aging mode method: 1, press
on the remote control Left and right the cursor keys will
Factory hotkey set to ON; 2, WARM UP is set to ON;
according to the panel on the "menu" button to exit the
aging mode
OK
3-ADC ADC calibration
（
refer as follow
），
NOTE: Not
adjust
OK
4-White balance White Balance data adjustment
（
refer as follow
）
The balance data is set by PE before the mass
production. Do not need adjust.
OK
5-SHOP
init(Option) DO Reset the set after production alignment;(This
operation will remove all unnecessary factory
value; The factory hotkey will be turn off) OK
6-NVM reset DO System initialization. Restore all data except
the White Balance and ADC data ;Only for R&D. OK
7-Preset Factory
Channel DO/HZ Preset specific factory channels for specific
factory. Press left and right button to select
the factory, and then press OK to confirm.
NG