6
7
1. Use description:
(1). Panel description of remote control
(2). Switch “OFF” when the remote is not used.
(The power switch is on the right)
(3). The Speed-Select key & Speed-Select indicator is used to select
the speed grade of the car. The grade will change in the range
of 3-leves: low (one Speed-Indicator flush), medium
(two Speed-Indicator flush) and high (three Speed-Indicator flush)
speed. The change of the order is LOW-MEDIUM-HIGH-MEDIUM-LOW
as the button pressed.
Note: Only the forward direction moving can own this function,
the backward not.
Battery installation
(4).Unfastening the rear cover screw and remove it, install 2 x AAA 1.5V
batteries. Be sure the correction of polarity of battery.
ON/OFF
FORWARD-KEY
BACKWARD-KEY
LED LIGHT(SPEED-INDICATOR)
SPEED-SELECT-KEY
LEFT-KEY
RIGHT-KEY
How to assemble the vehicle:
Step 1:
● Insert onto the front axle: wheel (#6),
Φ20x10.5x2 washer (#11), M8 nut (#10).
● Tighten the nut with wrench (#7).
Remark: If the axle is too long, please add
one piece of Φ20x10.5x2 Washer (#11)
● Attach the hub cap(#9) onto the front
wheel, insert 5xPA3x10x5 screws(#18) and
tighten with screwdriver (not included).
● Repeat the same step for other front wheel.
Step 4:
● Attach the rearview mirror (#2) onto the body.
Step 2:
● Insert the axle for rear wheel (#8) into the
hole of the body.
● Insert gearbox with motor (#4) onto the
rear right axle, then connect the white plug
to the motor plug.
● Then insert the wheel (#6), Φ20x10.5x2
washer (#11), M8 nut (#10).
● Tighten the nut with wrench (#7).
● Attach the hub cap (#9) onto the rear wheel.
insert 5xPA3x10x5 screws(#18) and tighten
with screwdriver (not included).
Step 3:
●
Assemble rear left wheel same as Step 2.
wheel (#6)
Φ20x10.5x2
washer (#11)
wrench (#7)
M8 nut (#10)
hub cap (#9)
PA3x10x5 Screw
wheel (#6)
M8 nut (#10)
hub cap (#9)
gearbox (#4)
wrench (#7)
Φ20x10.5x2 washer (#11)
White plug
PA3x10x5 Screw
4.
5.
Step 5:
● Undo the M5 screw (#14) and M5 nut (#15) from
the steering wheel (#1).
● Connect the plug of the steering wheel to the
plug of the vehicle.
● Place the steering wheel onto the steering wheel
column.
● Insert the screw through the hole of the steering
wheel.
● Attach the nut to another side of the steering
wheel, tighten the screw with the screwdriver
(Not included)
