KAKA Industrial W01-2422, Руководство по эксплуатации, Страница: 4 / 8

Bolt (#35) clockwise.
c. To increase the distance, turn the Adjusting Bolt (#35)
counterclockwise.
3. Adjust distance between Shaft 1 (#8) and Shaft 3 (#7) if necessary
a. The distance between Shaft 3 (#7) and Shaft 1 (#8) can be adjusted
by turning the Adjusting Bolts (#22).
b. To decrease the distance between the two shafts, turn the Adjusting
Bolts (#22) clockwise.
c. To increase the distance, turn the Adjusting Bolts (#22)
counterclockwise.
4. Removal of Shaft 1 (#8) if necessary. The left end of Shaft 1 is mounted
on a Square Bushing (#5), and the right end of Shaft 1 is mounted
through the Right Stand (#9) into the Sleeve (#10).
a. To remove Shaft 1, remove the Sleeve (#10) off the right end of Shaft
1.
b. Next, at the top of the Left Stand, loosen Hex Bolt (#3).
c. Pull the right end of the Shaft 1 outward.
5. Remounting Shaft 1
a. Reinsert the right end of Shaft 1 into the hole in the Right Stand.
b. Tighten Hex Bolt (#3) on the top of the Left Stand.
c. Push the Sleeve (#10) onto the end of Shaft 1.
Operation
Before using, check the mounting and adjustment of this machine. Rotate
the Handle (#23) and check whether the four gears (#19, #30) have good,
firm contact with each other. Shafts 1, 2 and 3 should be clean and free of
metal debris. Refer to the Parts Diagram.
Forming Rolls
1. Insert the steel plate between Shaft 1 (#8) and Shaft 2 (#20).
2. Rotate the Handle (#23) to form the metal roll.
3. If the diameter of the metal roll is not correct, turn the Adjusting Bolts (#22)
clockwise to decrease the diameter, of counterclockwise to increase the
diameter of the roll.