Operation Manual RM-08
Model RM-08
— 6 —
Troubleshooting Chart
Symptom
Possible Cause(s)
Corrective Action
Dies cut through
metal
1 . D i e s a r e t o o c l o s e
together
1. Adjust die position using adjusting
handle (# 60)
Dies do not make
the form correctly
1. Dies are improperly
adjusted
2. Thumb screw loose (# 36)
3. Workpiece material too
thick
1. Adjust die position using adjusting
nut (# 27)
2. Tighten thumb screw
3. Do not exceed machine capacity
of 0.030” mild steel or equivalent,
See Equivalency Chart
Crank arm difficult
to turn
1. Adjusting block (# 35)
l o o s e o r n o t i n p r o p e r
position
2.Improper lubrication
1.Adjust set screws (# 21) and
secure by tightening lock nuts (#
20). Loosen knob (# 22) and adjust
position of adjusting block (# 35)
by turning adjusting bolts (# 33).
Retighten knob (Ref. No 22).
2 . L u b r i c a t i o n p r o p e r l y, S e e
Lubrication