I
NSTALLATION
INSTRUCTION
T
o install the hood proceed as follows:
•
Install the wall hanger
1
at the appropriate level,
•
Hang the hood body
2
on the hanger
1
,
•
Connect the hood to the ventilation duct,
•
Connect the hood to the power network,
INSTALLATION OF THE WALL HANGER
•
Trace a vertical line on the wall to indicate the
center of the cooker plate.
•
Hold a hood hanger profile
1
to the wall, set it
symmetrically in relation to the central line, with
the distance between the holes in the profile and
the cooker plate amounting to min. 1062 mm,
level the profile preliminarily, indicate the spacing
of mounting holes on the wall.
•
Drill the holes as indicated on the wall, using drills
of diameter corresponding to the attached
expansion plugs, drive the plugs in and then
screw the hanger profile to the wall.
INSTALLATION OF THE HOOD
•
Hang the hood body
2
on the installed hanger
1
,
level it with adjusting screws
3
and then tighten
the screw
4
preventing the hood from sliding off
the hanger
.
I
•
Connect the hood to the power supply network.
•
On an exhaust vent
5
establish the V-flap
6
.
•
In the extractor mode of the cooker hood it is
necessary to mount a vent conduit of Ø 150 mm
on the fixed V-flap
6
. By connection of a conduit of
Ø 120 mm use an adapter
7
.
•
f the cooker hood will be operate in odour
absorber mode it is necessary to buy and install a
charcoal filter
(
180 × 310 × 10
m
m
)
(see p. 24).
EN
6
2
4
1
2
3
5
7
6