Tigertop™ – Installation Instructions
Raise the Rear Bow
Rear
Bow
Front
Bow
Insert tab
into third
hole
Do not use
this hole!!
Install Front Snaps
Install Remaining Snaps
Slide the Rear Bow up on the Front Bow and insert
the small bent tab into the third hole from the bot-
tom in the Front Bow.
Locate and Install the Front
Body Stud on Both Sides
Install the remaining Body Studs on the Side
Panels and the Tailgate. Alternate from side to side
as you install the studs. Snap the top to each new
stud to keep the tension on the top spread evenly.
Thread the Buckle Straps, on the Rear Bow,
through the Footman Loops. Pull them up and
thread them through the buckle.
Thread Buckle
Straps through
Footman Loops
Secure Buckle Straps
If the top is extremely tight, slip the tab
into the bottom hole. The top will loosen
up after a few hours in the sun. Then the tab may
be moved up into a higher hole position.
At the front of the Side Panel, pull the fabric down and
forward to eliminate wrinkles. Mark, center punch and
install a Body Stud as before 3/4" below the top edge
of the body. Do this on both sides of the vehicle.
Important:
At the bottom of the Rear
Curtain, there is a flap with five snaps.
This flap allows this top to adapt to vehicles that
have tailgates as well as to those that do not have
tailgates.
If you have a vehicle with a flat tailgate or with no
tailgate, use the snaps on the bottom of the Rear
Curtain. If you have a tailgate with an extrusion on
the top, use the snaps on the flap.
