Page - 5
R
EMOVING
& R
EPLACING
THE
D
ETENT
D
ISC
Once the Indexing Hub is removed, the detent disc can be removed from its re-
cess in the bottom of the Vertical Bracket. The disc may slip out once the Index-
ing Hub is removed. If it sticks inside the recess, simply insert the tip of a ballpoint
pen or a pin small enough to fit into the detent disc ejection hole on the top of
the bracket and push the detent disc out of the detent disc recess.
With the disc removed, a different disc can be inserted to change the angular
spacing. The 14 position detent disc (included with your bracket) is for use with
the optional Fujifilm 0.8X wide angle lens (available from Fujifilm for the Fuji MX-
2900 camera).
To install a different disc, simply align the keyed slot and push the disc into the
recess. Make sure the disc is properly seated and flush to the bottom surface of
the Vertical Bracket. With the new disc inserted, reassemble by inserting the In-
dexing Hub back through the bearing in the Vertical Bracket.
R
EPLACING
THE
F
RICTION
C
AP
Replace the Friction Cap by threading the Cap back onto the axle. Continue to
thread the cap so that there is no free play between the Vertical Bracket and the
Indexing Hub. The rubber washer on the bottom of the Friction Cap should be
slightly compressed. When the drag feels adequate, turn the Friction Cap so that
the threaded shaft of the Retaining Knob is aligned with the closest flat on the
axle. Tighten the Retaining Knob to lock the Cap in place.
