kago 1001950, Руководство пользователя

Страница: 17 / 113

1 Cover 4 Base
2 Side section - upper 5 Side section - lower
3 Clamp (4x) 6 Cardboard packaging with mount and mounting kit
↻ The device is transported to the installation location.
1. Remove the plastic band from the pallet and packaging.
2. Pull the clamp off the packaging.
3. Pull the hood upwards to remove it and place the cardboard packaging to one side together with the mount and ac-
cessories.
4. Set the unit with base and side sections upright.
5. Remove the top side section and base from the device.
ð If the unit is in the correct installation position: Proceed with the installation of the mount.
6.3 Fastening the mount
WARNING
Hazard when using unsuitable fixing materials!
If unsuitable fixing materials are used, the device could fall and persons in front of the device may be seriously
injured.
1. Use only fixing materials that are suitable for the mounting base. The fastening materials supplied are only
to be used for masonry and concrete.
2. Only install the device in an upright hanging position.
153 mm
A
A
B
C
D
1
2
3
4
5
6
75 mm
A
Detail A
Fig. 15: Minimum clearances for wall mounting
1
6
5
270 mm
475 mm
475 mm
270 mm
1)
1)
1066 mm
458 mm
550 mm
453 mm
2)
1)
1)
1543 mm
Fig. 16: Wall mounting
Legend
1 Mount 4 Screw for mounting (4x) [SW 13 / [See sec-
tion 6.3
} Page 17]]
2 Fastening anchors [S12-Ø12 mm / 25 mm ] 5 Screw for securing purposes (1x)
3 Lock washer 6 Bracket to store the device
A Minimum clearance: 120 mm
1)
Minimum clearance excluding device:270 mm
Recommended clearance: 400 mm
1)
Recommended clearance excluding device:475 mm
B Minimum clearance: 300 mm - -
C Minimum clearance: 500 mm - -
D Recommended clearance: 1000 mm ²) Recommended clearance with DC breaker:1543 mm
↻ Cardboard packaging with mount and mounting kit removed from the packaging and opened.
Manual Assembly and preparation | 6
KACO blueplanet 100 TL3
Page 17
EN