Page 10
Operating Instructions Powador 3200 / 4400 / 5300 / 5500 / 6600_EN
4.6
Level 2 menu – Confi guration mode
Software version
Confi
guration
version
Serial
no.
Current
country
Language
selection
Clearing the feed-in meter
Defi ne total yield? (yes/no)
Defi ne total yield, if (yes) was previously selected
Select interface (RS232/RS485)
Settings for the RS485 address
S0
interface
Activate Relay 33
- Relay 33 activation prompt (yes/no)
-
Password
prompt
Defi ne switch-on power for Relay 33
Defi ne relay switch-on time for Relay 33
Activate power boost
Quick
start
Figure 4.5:
Confi guration mode menu
Explanation of the individual menu items:
Software version
The current software version is displayed here.
Confi guration version
The confi guration version is displayed here.
Serial no.
Display of the serial number specifi c to the unit.
Current country
Display of the current country settings.
Language selection
The language of the confi guration interface can be selected
here.
Clearing the feed-in meter
When the feed-in meter is cleared, all counters (“Counter
yield” and ”Counter oper. hours”) are reset to zero. To clear
the counters, select ”Yes” with key “2”, and confi rm your
selection by pressing the ”1” key. The required code is ”2”,
and is entered using key “2”. After confi rming again with
key “1”, all counters are cleared. ”Feed-in meter cleared!” is
shown to confi rm that the counters have been cleared.
“Counter yield” and ”Counter oper. hours” can be cleared sepa-
rately from the other counters. These counters are cleared in the
confi guration menu using key ”2” and the code ”2”. ”Counter
yield” and ”Counter oper. hours” are always cleared together.
Set total yield
Choose whether the total yield should be defi ned (yes/no).
Set total yield
Specify the counter reading for the total yield so that the coun-
ter does not begin at zero after start-up.
Interface selection
Key ”2” is used to switch between interfaces RS232 and
RS485.
Choice of interface and address setting
Using the ”Select interface” menu item, you can use key ”2”
to switch between the RS232 and RS485 interfaces.
If the RS485 interface is activated, you can reach the address
setting by pressing key ”1”. By pressing key “2”, the address
can be set in a consecutive manner from 1 to 32. The address
then returns to 1.
The RS485 interface is used to communicate with the Powa-
dor-proLOG. If several inverters are connected to a Powador-
proLOG, each address may only be used once. This makes it
possible to monitor 32 Powador inverters with one Powador-
proLOG.
To connect the RS485 interface, please contact your installer.
S0 interface pulse rate
The S0 interface is designed as a galvanically isolated transis-
tor output. This interface is designed according to DIN
EN 62053-31:1999-04 (Pulse output devices for electrome-
chanical and electronic meters).
The S0 interface pulse rate can be chosen in three unit inter-
vals: 500, 1,000 and 2,000 pulses/kWh.
To connect the S0 interface, please contact your installer.
S e c t i o n 4 ·
O p e r a t i o n
ACTION
To access the confi guration mode, press both keys at the
same time. The software version is displayed. Pressing
key ”1” now switches to the next menu item. Changes
can be made in the respective menu item by pressing key
”2”. The setting value increases each time key ”2” is
pressed. If the maximum value has been reached, the
value returns to the minimum setting option.
