Kabuto AERO-V1, Инструкция по эксплуатации, Страница: 20 / 28

CAUTION!
Mounting part
XF-7 Adjuster XF-7 Adjuster
Fig. 1
Hold the XF-7 Adjuster around the mounting part firmly
and move it up and down among the three positions as
illustrated (Fig.1, Fig.2.) The fourth hole is for
detaching the XF-7 Adjuster (Fig.2).
In adjustment, move the XF-7 Adjuster slowly to avoid
from accidental detachment.
Setting the XF-7 Adjuster Position
Detach/Attach the XF-7 Adjuster
In adjustment, never fail to hold the mounting part.
Twisting forcefully moving the XF-7 Adjuster may
cause its breakage. Please pay due caution in
adjustment.
To detach
Hold firmly the XF-7 Adjuster around the mounting
part, move it to the fourth hole position, and twist it
either right or left a little as illustrated (Fig.3.) Be
reminded that moving the mounting part past third slit
to the fourth hole gets a little tighter. Then, hold around
the arm fixing base portion, pull the XF-7 Adjuster
slowly to detach the mounting part.
To attach
Place the thumb between the mounting part and the
inner surface of the shell and lift it a little as illustrated
in Fig.4. Align the XF-7 Adjuster fourth hole with the
bump on the mounting part, press the XF-7 Adjuster
hard and slide it down. Press the bump on the tip of
the XF-7 adjuster arm
into the fixing hole
(basket) on each
side.
After mounting the
XF-7 adjuster, make
sure the chinstrap
relative position to the
XF-7 adjuster as
illustrated in Fig.5
❶
❷
❸
The fourth hole
Adjustable at
3 angles
Fig. 2
Fig. 3
Move the
mounting hole to
the fourth hole
position and
twist a little.
Chinstrap
Mounting part
bump
Fig. 4 Fig. 5
XF-7
Adjuster
XF-7 Adjuster
Place the
thumb under
the part
and lift the
Adjuster a
little.
Let the chinstrap go
through the XF-7 adjuster
as illustrated.
19