KABEL
Precautions for Use
Pay attention to the following instructions while using this product. Our company
is not liable for damages caused by user errors.
1.
Water level must never exceed “MAX” point on display and must not fall
below “MIN” point during cooling.
2.
When rate of humidity increases, humidity can be adjusted according to
room temperature.
3.
When water is added avoid tilting and/or hitting the appliance while
relocating it to prevent overflowing. In order to prevent accidents do
not turn the appliance upside down.
4.
Do not place anything in front of cooler. Do not cover air throw diffuser.
Make sure there are no obstacles closer than one meter to the
appliance while it is operating.
5.
If water tank is empty pump would not function when cooling function
is turned on.
6.
Cut off the power before cleaning and maintenance.
7.
While cleaning outer parts of the appliance use a damp cloth (or with
some detergent) and avoid using corrosive detergents, solvents and
water.
8.
If the appliance gets toppled with water inside, pull off the plug
immediately and do not restart before the appliance is completely dry.
9.
Air flow openings must not be near walls, curtains, and the like material.
Otherwise will decrease air flow effect.
10.
While in use this appliance must not be exposed to impact or shaking.
This might cause automatic shutdown that can be fixed with rebooting.
11.
Unplug the appliance from power source when not in use.
Note: No part of the control panel must get wet. Due to high pressure
inside the appliance, it must be unplugged from power source before
cleaning.
12.
In case power chord is damaged, it must be replaced by qualified staff of
producer company or maintenance department to avoid accidents.
13.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory, or mental capabilities.
14.
Do not allow children to play with the appliance.
KABEL
Cleaning
Dust Filter
Unplug the appliance, unbolt, press and pull back tabs of dust filter to
remove the filter. Clean the dust filter with soapy water and a soft brush.
Dry and properly reinstall.
Wet Pad
Unplug the appliance, remove dust filter and pads to rinse with water and
reinstall.
Note: Water pressure must not be high during cleaning. Do not use acidic
or alkali detergent while cleaning the pads.
Water Tank
Unplug the appliance. Open water outlet cap on rear section to discharge
waste water and add clean water.
Advice:
Change water daily to avoid bad odor.
