KABEL
Installation and Use
1.
Open the box and take out the cooler
2.
Adding water: Open water inlet on
the left side of cooler and fill tank
with water. Control level and amount
of water from water level indicator.
Please be careful of the following
while adding water.
Avoid contact of motor and its
surrounding area with water to keep
electrical parts undamaged.
Do not add water above “MAX” level.
Otherwise water would spill out of
appliance.
Make sure you use clean tap water
3.
For standby mode plug in and operate
the cooler by pressing on/off button.
Rate of blowing, motion of diffuser
blades, cooling and timing functions
can be set on need.
4.
When on/off button is pressed in
operating mode the appliance stops
working and enters standby.
KABEL
Manual Panel
Power
When the appliance is turned on power light
is on and signal sounds once after which the
cooler enters standby.
When ON/OFF button is pressed while
the appliance is plugged in, the cooler starts
working. If the appliance is restarted, it
returns to operating conditions it has while
ON/OFF button is pressed. In any working
mode, the cooler can be turned off by
pressing this button.
When COOL button is pressed the
appliance enters to cooling mode. Button light
is on and fan starts working on low speed.
When SWING L/R button is pressed
ventilation blades start moving and button
light is on. Button is pressed again to stop
diverting air.
When this button is pressed one of the
3 different velocity stages is chosen. (High,
medium, low speed)
With timer button requested operating
time of appliance operation is set.
Can charge 2.0A USB
Using mode button one of the modes
among natural breeze, sleep, and standard is
chosen
Light button turns screen light on and
off
