Kaba Simplex 506 Series, Руководство по установке

Страница: 26 / 28

26
M. INSTALLING RUBBER BUMPERS
M-1
Close the door and apply pressure making sure the
deadlatch rests on the strike plate. Standing on
the frame (door stop) side of the door, check for
gaps between the door and the frame on the three
sides of the frame (left, right, and top).
M-2
Mark locations where the gaps are approximately
3
⁄
16
” (5 mm). Make sure these locations are free
from grease and dust. Peel the bumpers (c)
(supplied) from their protective backing without
touching the adhesive surface and stick them on
the marked locations.
Note: Allow 24 hours for adhesive to set before testing.
The door may be operated normally during this time.
N. TROUBLE SHOOTING
SYMPTOM POSSIBLE CAUSE REMEDY
1. The outside lever always
retracts the latch after
depressing and releasing
the “ENTER” button only
(without combination).
Lock is in “ZERO”
combination. Follow the procedure for
Changing Combinations
(Section K) except omit
steps 1 and 2 (do not enter
the existing combination).
2. The outside lever always
retracts the latch after
depressing and releasing
the “ENTER” button only
(without combination).
Activation cam has
flipped over during lost
combination procedure. Remove outside housing
from base, remove
chamber and flip activation
cam back to correct
positon. Cams should face
opposite direction from one
another.
3. The outside lever
will not go completely
inside the outside lock
assembly.
Lever catch is
misaligned. Insert release tool through
small hole on the outside
unit assembly (under the
lever). Using the tool,
gently push lever catch
up until it clicks. Refer to
Section H or I (Installing
and Removing the Outside
Lever).
C
LIT1051_Simplex_506x _Mortise_1012.indd 26 1/7/13 3:13 PM