Battery Replacement
Read all instructions before attempting to replace the battery in an LC Series
lock. The battery is located in the keypad assembly.
REPLACE LC BATTERY
To replace the battery, you must
first remove the keypad assem-
bly.
For Lexan lock:
Insert the blade of a flat head
screwdriver under the keypad
housing at a point about 15
degrees to the right of 6 o’clock
on the face of the keypad
(below the Enter key). (See
Figure 1.) There is a small
indentation on the back edge of
the keypad housing that will
allow the screwdriver to easily
be inserted at this point. Pry the
keypad assembly from the face
of the safe being careful not to
damage the cable connection
from the safe to the keypad
assembly. (See Figure 2.)
For Metal lock:
Press the keypad release button
found on the bottom of the
keypad housing.
Remove the old battery and
replace with a new 9-Volt
battery. (See Figure 2.) Reattach
the keypad
being careful not to
pinch the battery cable
between the keypad housing
and the mounting bracket
.
Test the operation of the lock before closing the container. If the combination is
entered successfully, one green flash displays to indicate the lock is ready to
open. Rotate the container handle to retract the bolt. If the test is successful, the
lock and container are now ready for use.
If the lock does not operate successfully, remove the keypad once again to
check the cable and battery connections.
Battery Clip
Cable
Connection
Figure 2
Battery
Insert Blade of
Screwdriver
Under Keypad
Housing
Figure 1
Содержание LCLX
Страница 7: ...NOTES...
