PK3512_09_07 • REMOTE ACCESS CONTROLLER - 660G
3
1.0 Introduction and Disclaimers
Target Audience
Please read and follow all directions carefully. These instructions
are designed for use by lock installers or anyone who is familiar
with common safety practices and competent to perform the
steps described herein.
For a typical installation, no professional electrician is required
because the RAC 660G is a low voltage installation system.
Kaba Lodging Systems is not responsible for damage or
malfunction due to incorrect installation.
Safety Procedures
Installation is to be done following standard safety procedures
with adequate equipment prescribed herein and wearing
adequate protection for body safety. Power is to be off during
the installation process as well as for any maintenance
procedures.
Technical Assistance
For technical assistance call
1-800-906-4526
OR
Visit the Kaba Support Website:
http://connect.kabalodging.com
Warnings and Cautions
Please read and follow all directions
carefully.
!
Important: Carefully inspect windows, doorframe, door,
etc. to ensure that the recommended procedures will not
cause damage. Kaba Ilco’s standard warranty does not
cover damages caused by installation.
!
Important: The RAC 660G should always be installed in a
secured room or facility with controlled access to prevent
access to the system.
!
Caution: Wear safety glasses when making
the holes.
!
2.0 Product Description
2.1 Features
The RAC 660G is designed to operate electrical locking or
control devices where a stand-alone electronic lock is not
practical. The system
can control any door or access point
from up to 100 feet (30 m)
away. The 2X6 Keypad can be
mounted directly on doorframes, while the 3X4 Keypad is wall
mounted.
The RAC 660G is a simple access control solution for 1 Keypad
providing features as per the features list on page 3. See figure
1 for a typical configuration.
Power Adapter
Keypad
RAC 660G
RAC 4XT
Up to 2
Keypad
Up to 8 Relay Outputs
Battery Back-up
Power Adapter
Figure 1
