RAC Model 3.5 with KIM Swipe Reader
8
4.2 Hotel ID Reinitialization
To reinitialize the Hotel ID code:
1. Set the switches in switch bank S2 to CFG #16.
2. Swipe a new initialization keycard through the swipe reader. The red and green LEDs on the KIM
Swipe Reader will flash in sequence -red once, green twice.
3. Wait for the LEDs to flash as described, then set the DIP switch positions back to the chosen access
delay setting.
4.3 Battery Replacement (KABA ILCO Part #120-507947)
Warning: The power supply uses high voltage; only a qualified person
should replace the battery.
1. Prior to replacing the battery, write down the color and location of each wire and the orientation of the
batteries.
2. Disconnect all wires.
3. While holding the battery in place, remove both screws holding the retaining bracket.
4. Replace battery with the same type gelled lead acid cell 12 V, 7.0 AH (Ampere-hours). Put the new
battery in the same position, install the retaining bracket and reconnect all the wires. Dispose of the
old battery according to local regulations.
Note: For preventative maintenance, back-up batteries should be replaced every 2 to
3 years, and tested every 6 months by removing main AC power.
4.4 Power Failure
In the event of an electrical failure, the system will revert to standby status for a period of 4 hours
(if the
optional battery is installed)
. If the electrical power is restored within three days, the system will recover
automatically and should require no additional programming. Verify the status of the LED D18 on the con-
troller PCB in question. If the LED is OFF, swipe an initialization or start-up card through the reader and
reset the lock time to ensure that the controller will function properly. See Table 3 on page 5 for Status LED
definitions.
4.5 Loading Recommendations
Caution: Do not exceed the load limitations of the control panel.
The maximum recommended load for all output relays in the card reader control panel is 1 Amp at 30 VDC.
The tamper switch rating is 1 Amp for 115VAC and 0.5 Amp for 230VAC applications.
4.6 System Deactivation
In order to deactivate the card reader control panel, disconnect both terminals from the standby battery,
then disconnect the AC power either by removing the quick disconnect terminal located at TB1 of the power
supply or by shutting off the main breaker switch for the control panel.
