11
12
Display Settings
Mantis PRO 24.5Ah
The Mantis PRO scooter is equipped with the following LCD display:
Cruise Control.
Cruise control allows you to maintain your driving speed automatically without
continuing to hold down the accelerator. In order to enter Cruise Control, activate it first in the
P-settings [P6].
While driving, keep the accelerator steady for a few seconds until Cruise Control kicks in and
scooter travels at a constant speed without driver holding down the accelerator. When you
activate the brakes Cruise Control will be cancelled. CAUTION: Ride in a position where you can
immediately access the brake to cancel Cruise Control if necessary.
Speedometer: Shows the speed at which you are travelling.
Battery Indicator: Shows the level of the battery. Charge your scooter frequently, do not let it
run out of battery. As a rough guideline, charge at or below 2 bars.
Gear: Shows the selected gear.
Gear selector: Press to set gear (1=slow, 2=medium, 3=fast).
Power Button: To turn the scooter on or off, press button for 2 seconds.
Accelerator: Pull to accelerate. The stronger you pull, the faster it accelerates. The scooter is
delivered in “Non-Zero Start” setting (Kick-And-Go is ON). The accelerator only works if the
scooter is already in motion.
Mode Button. Press to select various display options:
MODE
COMMENT
TIME
Time since powering on the scooter.
TRIP
Distance travelled since powering on the scooter.
ODO
Total distance travelled.
VOL
Current battery voltage.
CHA
Number of times battery has been charged (only full discharges
are counted)
Detailed P-settings mode.
To access P-settings to make various advanced changes, press MODE
[7] for 2-3 seconds.
Switch through the P-settings using the MODE button [7]. In order to change a P-setting press
GEAR button [4]. To return to operating mode, wait a few seconds.
05
P-SETTINGS
P0
Tire diameter (8 for mantis 8, 10 for mantis 10). Do not change.
P1
Controller shut-down voltage. Default set to 52V (minimum is 48V – we recommend 52V to preserve battery life).
P2
Motor magnetic pole setting. Default is 30. Do not change.(Mantis 10)
Motor magnetic pole setting. Default is 20. Do not change.(Mantis 8)
P3
Speed signal selection. Default is 0. Do not change.
P4
Distance / speed unit. 0=km, 1=miles
P5
Start setting. 1=non-zero start (Kick-and-Go), accelerator won’t work if scooter is not in motion; 0
=immediate start (CAUTION while using this)
P6
Cruise control. 0=cruise control OFF, 1=cruise control ON.
P7
Initial acceleration. 0=soft, 1=strong.
P8
Electric (regenerative) braking (E-ABS). 0=E-ABS off, 1=E-ABS on
PA
Clear total distance travelled (ODO).
PB
Scooter auto-turn off time in minutes.
PC
Display brightness (1=low, 2=medium, 3=high)
Содержание Mantis 48V 13Ah
Страница 4: ...1 2 Technical Specifications...
Страница 5: ...3 4 Key Components MANTIS 10 MANTIS 10 MANTIS 8...
Страница 11: ...15 MEMO 06...