JUMP START A VEHICLE
1. Slide ON the POWER switch and make sure the Power Bank is
fully charged.
2. Turn off all accessories on the vehicle (radio, air conditioner, etc)
3. Connect the jumper cable’s RED clamp to the POSITIVE post of
the vehicle battery.
4. Connect the jumper cable’s BLACK clamp to the NEGATIVE post
of the vehicle battery.
5. Insert the jumper cable connector into the Power Bank’s 12V
6. Turn the vehicle ignition key for 3 seconds only. If the vehicle
starts:
•
disconnect the clamps from the battery.
• Leave the ignition on for a few minutes, then turn off the
vehicle.
7.
again.
CHARGING A 5V USB DEVICE (TABLET, CELL PHONE, ETC.)
1. Slide ON the POWER switch. Connect 3-1 USB connector to the
portable power bank unit.
2. Connect your device to either the miniUSB or microUSB cable.
3. The portable power bank unit begins to charge your device.
TURN ON FLASHLIGHT
1. Slide ON the POWER switch. Press and hold POWER button to
2. Press POWER button
again to cycle through the 4 modes: Steady,
Slow Strobe, Fast Strobe, and OFF.
CHARGE DC 12V/16V/19V DEVICES
Slide ON the POWER switch. Press POWER button to select the
desired output voltage (DC 12V/16V/19V). Insert a connector cable
(not included) to DC Output 2 to charge the desired device.