25 of 28
Troubleshooting
Symptom
Suggestion
KRX6
was
connected is now
not connecting
after mounting in
desired position
This indicates a lack of Wi-Fi signal. You will need to
move your
KRX6
and Wi-Fi router closer to each other
No LED lights on
This indicates that there is no power to the unit. Your
controller will not operate if there is an AC fault. Please
check the power point or plug transformer pack for
power. Using a multi meter is best for this action.
Replace the fuse.
If no power, there may be an issue with the controller.
Plug pack transformers for the indoor models are available
from Holman’s or your local electrical retailer. These
require a 1amp 240 to 24V AC/AC transformer.
Single zone
not working
Faulty solenoid coil, or break in field wire. Check solenoid coil (a
good solenoid coil should read around 33Ω on a multi meter).
Test field cable for continuity. Test common cable for continuity
No automatic start
Setup error,
MAIN DIAL
is in
OFF
position, or blown
transformer. If unit works manually then check the setup or
MAIN DIAL
position. If not, check the fuse (next to the terminal
block). If fuse doesn’t need replacing, then check the wiring and
transformer is supplying 24V AC (measured on a multimeter)
Buttons not
responding
Please contact our Customer Service team
Содержание KRX6
Страница 1: ...3 WARRANTY User Manual ...