10
(13) STP
This menu is to set tuning step when
adjusting frequency by CLARIFIER knob
Options:
10 Hz, 100 Hz, 1 KHz, 10 KHz
Default:
10 Hz
(14) CLA
This menu is to set functions turned by
CLARIFIER knob. Options are as follows:
FIN:
Fine regulation. When this option is selected, users can fine
tuning the receiving frequency by rotating the CLARIFIER
knob. In tuning process, the transmitting frequency can not be
regulated by the knob and “1” icon will appear on the LCD.
RT:
When this option is selected, users can regulate the frequency of
both transmitting and receiving. In tuning process, “2” icon will
appear on the LCD.
T:
When this option is selected, users can only regulate the
transmitting frequency. In tuning process, “3” icon will appear on
the LCD.
Default:
RT
COA:
When this option is selected, press PUSH and turn CLARIFIER
knob to realize COARSE function.
When pressing this key, "2" icon will appear on far left of the
LCD. Under this condition, rotate the CLARIFIER knob to change
frequency of both transmitting and receiving.
(16) ASQ
ASQ control setting. It has same function
with AQ button on the microphone.
Default:
OFF
(17) TOT
This menu is to set transmitting TOT time.
When pressing PTT key at a single time
longer than the due time setup in advance, the radio would stop
transmitting automatically and loudspeaker will emit voice prompt till
PTT key is released. Then, the radio can transmit again.
Options:
30-600s
Step:
30s
Default:
180s
(15) PUS
This menu is to set functions realized via
PUSH knob. Options are as follows:
T:
When this option is selected, press PUSH and turn CLARIFIER
knob to change transmitting frequency. When pressing this key,
"3" icon will display on the far left of the LCD. Under this condition,
rotate the CLARIFIER knob to change the transmitting frequency
only.
STP:
When this option is selected, PUSH function will change
Frequency Tuning Step of CLARIFIER knob. Press this key,
then the corresponding frequency bit would blink.
Default:
STP
(18) SC
This menu is to set Scan Type. Options are
as follows:
SQ:
When SQ is selected, scan would stop when a valid signal
is detected. The radio would resume scanning after signal
disappears for 5s.
TI:
When TI is selected, scan would stop when a valid signal is
detected. The radio would resume scanning 5 seconds later,
whether signal disappears or not.
Default:
SQ
