14
12. The most important menu functions
In this part of the user manual you will find a structured digest about the procedure for the
necessary settings in the main menu and its functions. If you pay attention to that
a riskless use of the DA 428 is ensured.
12.1 The „mute”- function
This function enables to mute separately every single channel of DA 428 with just one
touch of a button.
Pr 1 Preset 1
Output headroom info
Bass
Bass
Top L
Top R
For menu access
→
touch knob or panel
Pr 1 Preset 1
Channel 1
A
muted
Bass
EQ 123
long press tu unmute
Press for 1 second the encoder A / B / C or D to mute the channel. A repeated pressing of the
particular encoder causes the deactivation of the „mute“-function (see display).
If the „mute“- function was activated (before switching off the DA 428), the „mute“- function is after
switching on the DA 428 again still activated.
If you are pressing an encoder for a short time during the „mute“- function is activated, you will
see the state of the particular channel (it effects also when the „mute“- function is not activated).
12.2 switching input A and / or B between “analog” or “digital”
The DA 428 offers the opportunity to plug in four analogue audio signals or two analogue
and two digital audio signals. If you want to use a digital audio signal you have to switch
the input A or / and input B to „digital“ (see page 10). In the delivery status input A and
input B are switched to „analogue“. That means the DA 428 can be driven by four
analogue input signals.
Pr 1 Preset 1
Output headroom info
Bass
Bass
Top L
Top R
For menu access
→
touch knob or panel
←
Back Confirm OK
A*Preset
B Memory Card
C Display Mode
D LED Settings
↓
Item SELECT Page
→
5x
←
Back Confirm OK
A Power Management
B*System
C Software
↓
Item SELECT Page
→
←
Back Confirm OK
System
A*Input Mode
B Link Mode/Content
↓
Item SELECT Page
→
C Password
D RSNC baud rate
←
Back Confirm OK
System
Input Mode
In A analog
↓
Item SELECT Page
→
In B analog
Press the marked arrow keys of the navigation-pad one after another (like shown in the scheme),
to switch the input to „analogue“ or „digital“ (by the help of the encoder). After the correct
selection of the input press the OK-button and leave the menu with the left arrow key.
