11
9. Routing of input channels
Here you can set the routing for each input channel. This process depends on the input
signal (analogue or digital). That means, if you have chosen the input mode „digital“
(corresponds only for channel A + B, because this input channels can operate with a
digital audio signal, too; see page 13), the routing possibilities will be automatically
switched to digital (see table).
In the following table you will find all adjustable configurations (per channel), which can
be chosen.
Input signal
Display shows:
analogue or digital
A
or
d1(L) A/d1(L)
B
or
d2(L) B/d2(L)
C
or
d1(R) C/d1(R)
D
or
d2(R) D/d2(R)
C always (always analogue)
C
always
D always (always analogue)
D
always
A+B
or
d1(L+R) A+B/d1(L+R)
C+D
or
d2(L+R) C+D/d2(L+R)
C+D always (always analogue)
C+D
always
B+C+D (always analogue)
B+C+D
A+B+C+D
or
d1+d2 A+B+C+D/d1+d2
Example 1:
You will drive an actively channelled PA system with your DA 428 (the stereo input signal is
analogue and the subwoofers are driven mono). Please plug in the left input signal to input A and
the right input signal to input B of DA 428.
Adjust the „input mode“ for channel A and B to „analogue“ (see page 13). After this, please
choose the following routing:
Out C = A/d1(L)
– left top unit
Out D = B/d2(L)
– right top unit
Out A = A+B/d1(L+R)
– subwoofer (mono signal: sum A+B = -6dB)
Out B = A+B/d1(L+R)
– subwoofer (mono signal: sum A+B = -6dB)
Example 2:
You will drive a passively channelled PA system with two separately driven monitor systems
(passive) with your DA 428. The input signal fort the PA is digital and the monitor systems are
driven with two separately analogue input signals. Please plug in the digital input signal to input A
of DA 428 and the monitor signals to input C + D.
Adjust the „input mode“ for channel A to „digital“ (see page 13). After this, please choose the
following routing:
Out A = A/d1(L)
– left channel
Out B = C/d1(R)
– right channel
Out C = C always
– monitor system 1
Out D = D always
– monitor system 2
