PCIe/PXIe-6302 |
| 23
Table 13 A/D conversion time at different speed levels
In the default configuration, the rate level is set to Auto. The drive will automatically
select the lowest rate level which is according to the sampling rate and the number
of added channels.
If the user explicitly specifies the rate level, the driver will automatically limit the
highest sampling rate according to the number of added channels and the specific
rate level. If the user-setsampling rate exceeds the limit, the driver will automatically
revise it.
For a more detailed description of the relationship between Timing Modes and
sample rates, please refer to Section 5.2.3.
Learn by Example 5.2.2
Connect the K-type Thermocouple’s positive pole and negative pole to Terminal
Block’s TCO+ (Pin#35) and TCO- (Pin#1);
Open
Winform AI Continuous Raw Data
, Choose
Auto
in
Timing mode
. Set the
other parameters as shown;
Содержание PCIe/PXIe-6302
