XV-S40BK/XV-S42SL/XV-S45GD/XV-S30BK
1-6
Disassembly method
<Main body>
Removing the top cover (see Fig.1)
Removing the mechanism assembly
(see Fig.2,3)
Removing the servo control board
(see Fig.4)
1.Remove the two screws
A
attaching the top cover
on both sides of the body.
2.Remove the three screws
B
attaching the top cover
on the back of the body.
3.Remove the top cover from the body by lifting the
rear part of the top cover.
ATTENTION: Do not break the front panel tab
fitted to the top cover.
* Prior to performing the following procedure, remove
the top cover.
* There is no need to remove the front panel assembly.
1.Remove the three screws
C
attaching the mechanism
assembly on the bottom chassis.
2.The servo control board is removed from the connector
CN961 and CN701 connected with the main board
respectively.
3.Remove the mechanism assembly by lifting the rear part
of the mechanism assembly.
* Prior to performing the following procedure, remove
the top cover and mechanism assembly.
1.Disconnect the card wire from connector CN201 and
CN202 on the servo control board respectively.
2.Disconnect the flexible wire from connector CN101
on the servo control board from pick-up.
ATTENTION
At this time, please extract the wire after short-circuited
of two places on the wire in part
a
with solder.
Please remove the solder two places of part
a
after
connecting the wire with CN101 when reassembling.
3.Two places in hook
b
are removed, the servo control board
is lifted, and it is removed.
*Please remove lug wire when you do not remove
the mechanism assembly easily.
A x 2
B
B
B
Fig.1
C
C
C
CN703
CN702
Fig.2
CN701 CN961
Servo control
board
Main board
Mechanism
assembly
Fig.3
Hook b
Hook b
Servo control
board
Fig.4
Lug wire
