JVC VN-H237VPU, Инструкция по эксплуатации

Страница: 60 / 114

60
Internet Explorer Setting
Multicast Page (continued)
* The [Set values] in bold letters are factory defaults.
Memo:
●
If the camera power supply is turned Off during multicast streaming, the camera will restart multicast
streaming automatically after the camera is restarted.
●
Settings
A
~
F
are not displayed when the encoder is set to "OFF".
Settings (continued)
Encoder No.1 to
No.3 Sets the manual streaming of Encoder No.1 to Encoder No.3.
A
Encoding Displays the
A
Encode
B
being set for each encoder.(
A
Page 25)
[Display values: JPEG, H.264 Baseline, H.264 High, MPEG-4)]
B
FrameSize Displays the "FrameSize" being set for each encoder. (
A
Page 24)
C
FrameRate Displays the
A
FrameRate
B
being set for each encoder. (
A
Page 24)
You can change it if the encoding is
A
JPEG
B
.
[Set values: 1/30 to 5 to 30 fps ]
Memo:
●
You can change the frame rate if it is below the limit specified on the
[Basic Setting2] page or on the [Encode] page.
D
Destination
Address Sets a destination address for encoded data streaming.
Set a multicast address. If you have another device for multicast streaming,
set a different multicast address.
[Factory default: Encoder No.1: 255.0.1.1, Encoder No.2: 255.0.2.1,
Encoder No.3: 255.0.4.1]
E
Destination
Port Sets a destination port number for encoded data streaming. Enter an even
number to meet the RTP. If you have another device for multicast streaming,
you should set a different port number.
If a port number is duplicated, you cannot receive multiple number of
multicast data using a single PC.
[Factory default: Encoder No.1: 49152, Encoder No.2: 59152, Encoder
No.3: 29152]
F
Start Saves the encoder settings, and starts manual streaming. The [Stop] button
is displayed during manual streaming.
You cannot change the frame rate, destination address, and destination port
during data distribution.
Memo:
●
To save the settings made to the entire page, press the [OK] button.