JVC V.NETWORKS VN-C625U, Руководство пользователя

Страница: 15 / 187

E-15
ENGLISH
Connect the alarm input/output terminals to
external devices such as sensors and buzzers.
1
Loosen the screws on both edges of the
terminal block using a flathead screwdriver,
followed by dismantling it as shown in the left
diagram.
2
Strip the coating of the alarm signal cable by
about 4mm before inserting it into the terminal.
3
Turn the screw on the side to fasten the alarm
signal cable.
4
Upon fastening the alarm signal cable, re-
install the terminal block that has been
dismantled in Step 1.
2. Connection to Alarm Input/Output Terminal
Connect this terminal to an infrared, door or
metallic sensor, or to a manual switch.
Input Requirements
●
No-voltage relay or NPN open collector input
●
The polarity of input detection can be selected
via software
●
Make/Break/Toggle (at least 250 ms)
●
Circuit current at low-level: 1.2 mA
●
Voltage applied at high level: 12 V
䡵
Alarm Input Terminal
4 mm
1
2
3
1
4
OUT
R
DC12V
GND
1.2mA
R
VCC
OUT
GND
12V
Flathead
Screwdriver
Alarm Signal
Cable
Flathead
Screwdriver
VN-C625
Terminal
1 or 2
(Alarm Input
Equivalent Circuit)
Grounding
Terminal
Sensor
Connection
Example (1)
Relay, switch,
etc.
Sensor
Connection
Example (2)
Note
Cable Specifications
50 m or shorter in length
UL1007, UL1015 or equivalent
AWG#22 to AWG#18 or equivalent
Caution
Due to external noise, the cable may not
function properly even when the cable length
is less than 50 m. In this case, use a shielded
cable or take measures such as keeping the
cable away from the noise source.
625 LWT0251-001A-H 05.3.25, 1:51 PM 15