JVC TK-C215VP12, Инструкция по эксплуатации

Страница: 15 / 36

11
Camera (Interior)
L
Rotation Knob
Rotate the lens unit to adjust the inclination of
the image. (
A
Pg. 22)
M
Rotation Center Mark (
A
Pg. 22)
N
Fall Prevention Wire
Use this to connect the base
G
to the dome
cover
D
.
O
Camera Unit Fastening Screw
⳯
2
Use this to fasten the camera unit
Q
to the base
G
.
To remove (
A
Pg. 17)
P
[MONITOR]Monitor Terminal (Pin Jack)
(
A
Pg. 22)
Q
Camera
R
Connector for Power Supply of Heater
This is a power connector for use when the
heater (sold separately: KA-ZH215) is mounted.
S
Space for Heater
T
Camera Unit Fastening Lug
⳯
2
This lug is used for fastening the camera unit to
the base. When removing the base, press
toward the direction indicated by the arrow to
release. (
A
Pg. 17)
U
Tilt Fastening Screw
Upon adjusting the angle of view, tighten the
screw to ensure that camera’s angle of view
does not go out of alignment when it is used at a
location with strong vibration. (
A
Pg. 22)
V
Shooting Direction Mark
Install the camera by aligning the shooting
direction with the arrow mark.
W
Lug Plate
This plate is used for fastening the silica gel.
(
A
Pg. 21)
X
Space for Silica Gel
(
A
Pg. 21)
P
Q
R
L
M
T
U
V
W
O
X
N
S
Lens
(
A
next page)
TK-C215VP4_JP.book Page 11 Wednesday, September 20, 2006 5:48 PM