(No.MB428)1-17
3.3.2 Removing the DVD servo board
(See Figs.6 to 8)
Caution:
Solder the short land sections
d
on the DVD pickup before dis-
connecting the card wire extending from the DVD pickup. If
you do not follow this instruction, the DVD pickup may be dam-
aged.
(1) From the topside of the DVD changer mechanism assem-
bly, solder the short land sections
d
on the DVD pick up.
(See Fig.6.)
(2) From the bottom side of the DVD changer mechanism as-
sembly, disconnect the card wire from the connectors
(
CN201
,
CN451
) on the DVD servo board. (See Fig.7.)
Reference:
When connecting the card wire to the connector
CN451
,
pass it through the sections
e
on the DVD traverse
mechanism assembly. (See Fig.7.)
(3) Disconnect the wires from the connectors (
CN452
,
CN453
)
on the DVD servo board. (See Fig.7.)
(4) Remove the two screws
B
attaching the DVD servo board.
(See Fig.7.)
(5) From the reverse side of the DVD servo board, release the
lock of the connector
CN101
in the direction of the arrow
and disconnect the card wire. (See Fig.8.)
Caution:
Unsolder the solders from the short land sections
d
after reas-
sembling. (See Fig.6.)
3.3.3 Removing the switch board
(See Fig.7)
(1) From the bottom side of the DVD changer mechanism as-
sembly, remove the screw
C
attaching the switch board on
the DVD changer mechanism assembly.
(2) Disconnect the wires from the connectors (
CN452
,
CN453
)
on the DVD servo board.
(3) Release the wires from the section
f
and remove the switch
board.
(4) Release the wires from the sections
g
and remove the
switch board.
Reference:
When reassembling, pass the wires through the sections (
f
,
g
)
as before.
Fig.6
Fig.7
Fig.8
DVD pickup
DVD changer mechanism assembly
d
C
DVD changer mechanism assembly
B
B
CN201
e
CN453
CN451
Switch board
DVD traverse mechanism assembly
DVD servo board
f
g
CN452
DVD servo board
CN101
Lock
