9
Listening to the Radio
The following operations are explained using
the remote control, unless mentioned otherwise.
However, if the System has the same or similar button
names, they can also be used for the operations.
Basic Tuner Operations
To select a band
(On the System)
Press repeatedly to select the band:
*
Appears only if DAB/FM/AM (TUNER)
button on the System is pressed.
• The selected frequency band
appear.
• When an FM stereo broadcast or a
DAB service with sufficient signal
strength is tuned in, the S (stereo)
or TUNED indicator lights up
respectively.
When you change the source to
DAB for the first time after plugging
in the AC power cord, the System
automatically scans the DAB bands
for available ensembles. (See page
10.)
(On the remote
control)
To change the FM reception mode
(When an FM stereo broadcast is hard to receive)
Press to improve reception.
The M (mono) indicator lights up.
Stereo effect will be lost.
To restore the stereo effect,
press
again.
For FM/AM
To select a frequency
or
Press and hold for more than 2
seconds.
The System starts searching for
stations and stops when a station of
sufficient signal strength is tuned in.
• Press during searching to stop.
• Press repeatedly to change the
frequency step by step.
To tune in to a preset station
or
Press to select its preset number.
• For presetting stations, see the right
column.
For DAB
To select an ensemble
or
Press
4
/
¢
while “ENSEMBLE” is
displayed.
• You can select from the ensembles
found in the ensemble scanning.
To select a service (either primary or secondary)
or
While tuning in to a service, press to
change services.
• When you reach the last/first service
of an ensemble and press
¢
/
4
,
you skip to the next/previous
ensemble respectively. It may take
some time to change ensembles.
• If the System is not tuned in to any
services, pressing
¢
/
4
will start
selecting an ensemble.
To tune in to a preset service
or
Press to select the preset number of
the pre-selected services.
• For presetting services, see below.
To tune in to all ensembles
1
“ENSEMBLE” appears on the display.
2
or
Press and hold for more than 2
seconds.
The frequency changes every
second through all ensembles
regardless of the signal status.
• Release the button when the
desired ensemble is reached.
Presetting Stations and Services
You can preset 30 FM stations, 15 AM stations, and 30
DAB services manually.
1
Tune in to a station/service you want to preset.
• You can also store the monaural reception
mode for FM stations.
2
Press to activate the preset number
entry mode.
• Finish the following steps while
the indication on the display is
flashing.
3
or
Press to select a preset number
for the station/service you want to
store.
EN01-12_UX-G800D[B]f.indd 9
EN01-12_UX-G800D[B]f.indd 9
3/5/08 3:42:09 PM
3/5/08 3:42:09 PM
