3
English
ANTENNA
AM
EXT
AM
LOOP
FM 75
COAXIAL
AM
LOOP
ANTENNA
AM
EXT
FM 75
CO
AX
IAL
AM
LOOP
ANTENNA
AM
EXT
FM 75
CO
AX
IAL
Getting Started
This section explains how to connect audio/video components and speakers to the receiver, and how to connect the
power supply.
Before Installation
General
• Be sure your hands are dry.
• Turn the power off to all components.
• Read the manuals supplied with the components you are going to
connect.
Locations
• Install the receiver in a location that is level and protected from
moisture.
• The temperature around the receiver must be between –5˚C and
35˚C (23˚F and 95˚F).
• Make sure there is good ventilation around the receiver. Poor
ventilation could cause overheating and damage the receiver.
Handling the receiver
• Do not insert any metal object into the receiver.
• Do not disassemble the receiver or remove screws, covers, or
cabinet.
• Do not expose the receiver to rain or moisture.
Checking the Supplied Accessories
Check to be sure you have all of the following items, which are
supplied with the receiver.
The number in the parentheses indicates quantity of the pieces
supplied.
• Remote Control (1)
• Batteries (2)
• AM Loop Antenna (1)
• FM Antenna (1)
• AC Plug Adaptor (1)
If anything is missing, contact your dealer immediately.
Setting the Voltage Selector Switch
Before connections, always do the following first if necessary.
Set the correct voltage for your area with the voltage selector switch
on the rear panel. Use a screw driver to rotate the switch so the
number the arrow is pointing at is the same as the voltage where you
are plugging in the receiver.
A. Using the Supplied FM Antenna
The FM antenna provided can be connected to the FM 75
Ω
COAXIAL terminal as temporary measure.
B. Using the Standard Type Connector (Not Supplied)
A standard type connector should be connected to the FM 75
Ω
COAXIAL terminal.
Note:
If reception is poor, connect the outdoor antenna.
Before attaching a 75
Ω
coaxial cable (the kind with a round wire
going to an outdoor antenna), disconnect the supplied FM antenna.
Connecting the FM and AM
Antennas
FM Antenna Connections
B
FM Antenna
Outdoor FM Antenna Cable
Extend the supplied FM antenna horizontally.
A
VOLTAGE SELECTOR
220V
230
-
240V
127V
110V
Voltage Mark
EN01-09.RX-7001PGD[U,US]/f
00.5.31, 10:53 AM
3
Содержание RX-7001PGD
Страница 28: ...2 1 ...
Страница 47: ...RX 7001PGD 3 2 MEMO ...