Warning Messages
If the lamp replacement was successful, the television will operate
normally. If there was a problem with the installation, one of several
messages may display on the front panel LED lights.
Lamp installed on a slant or not fully inside the television.
If the lamp assembly has been installed into the unit slanted (not flat)
or is not fully inserted into the lamp housing inside the television,
when the television is turned on the ON TIMER and POWER light
will flash. The 10 LEDs will light, then turn off one each five seconds.
When all LEDs are off, the television still will not display a picture.
To correct: Reinstall the new lamp assembly. Repeat the lamp instal-
lation steps, taking care to observe all warnings. Make sure when
the lamp assembly is reinstalled, it is inserted into the unit so it sits
FLAT inside the unit.
• If the ON TIMER light and/or POWER light is flashing you need to
reset the television. Reset the television by unplugging the power
cord from the AC outlet and then plugging the cord back into the
outlet again a little later.
Filter not properly reinstalled.
If the filter assembly has not been correctly reinstalled or if the filter
has been damaged, the television will not turn on. When the Power
button is pressed the 10 LEDs will turn on, then one will turn off
every five seconds. When three have turned off the television will
then enter a cool-down mode and the power will turn off.
To correct: Check to see that the filter has been installed properly.
Repeat steps 1 to 5 and 8 to 10. You do not need to remove and
reinstall the lamp. If the television still does not turn on, the filter may
have been damaged. Call a service technician for repair.
If the television does not work properly, or displays a message not
listed here, call a technician for service.
8
