(No.MB080)1-15
3.3.6 Removing the CD mechanism holder assembly
(mechanism included)
(See Fig. 10 to 13)
(1) Disconnect the harness from connector on the CD mecha-
nism board in the CD mechanism assembly on the under
side of the CD changer unit. Disconnect the card wire from
the pickup unit connector.
Attention :
Solder is put up before the card wire is removed from the
pick-up unit connector on the CD mechanism assembly.
(Refer to Fig.9) (When the card wire is removed without
putting up solder, the CD pick-up unit assembly might
destroy.)
(2) Remove the screw
E
attaching the shaft on the right side of
the CD mechanism holder assembly. Pull outward the
stopper fixing the shaft on the left side and remove the CD
mechanism holder assembly from behind in the direction of
the arrow y.
(3) Turn the CD mechanism holder assembly half around the
lift up slide shaft
h
of the CD mechanism holder assembly
until the turn table is reversed, and pull out the CD mecha-
nism holder assembly.
Fig.10
Fig.11
Fig.12
Fig.13
Motor connecter
CD mechanism holder assembly
CD changer unit
Pickup unit connector
E
CD mechanism holder assembly
Stopper
CD mechanism holder assembly
Lift up slide shaft
n
y
Lift up slide shaft
CD mechanism holder assembly
Содержание MX-GA8
