72
EN
INDEX
Indications (cont.)
Indications
Function
●
Appears when the date/time is not set.
(
墌
pg. 9)
●
Appears when the built-in clock battery runs out and the
previously set date/time is erased. Consult your nearest JVC dealer
for replacement.
Appears for 5 seconds after power is turned on if the lens cap is attached.
Appears if Audio Dubbing is attempted on a blank portion of a tape.
(
墌
pg. 58)
●
Appears if Audio Dubbing is attempted on a tape recorded in the LP
mode.
(
墌
pg. 58)
●
Appears if Audio Dubbing is attempted on a tape recorded in 16-bit
audio.
(
墌
pg. 58)
●
Appears if A. DUB (
e
) on the remote control is pressed when the erase
protection tab is set to “SAVE”.
(
墌
pg. 58)
Appears when the built-in memory is full and shooting is not possible.
●
Appears if the built-in memory is full when dubbing still images recorded
on the tape to the built-in memory.
(
墌
pg. 47)
●
Appears in the following cases when dubbing still images stored in the
built-in memory to a tape:
– when condensation occurs.
– when no tape is loaded.
– when the erase protection tab is set to “SAVE”.
– when a tape in another format is loaded.
– when the tape ends.
(
墌
pg. 46)
Appears if there are no images stored in the built-in memory when the
Power Switch is set to “
” and the VIDEO/DSC Switch is set to “
”.
The error indications (E01 — E06) show what type of malfunction has
occured. When an error indication appears, the camcorder turns off
automatically. Remove the power supply (battery, etc.) and wait a few
minutes for the indication to clear. When it does, you can resume using the
camcorder. If the indication remains, consult your nearest JVC dealer.
SET DATE/TIME!
NO IMAGES STORED
COPYING FAILED
MEMORY IS FULL
E01 — E06
UNIT IN SAFEGUARD
MODE REMOVE AND
REATTACH BATTERY
A. DUB ERROR!
<CANNOT DUB
ON AN LP RECORDED
TAPE>
<CANNOT DUB
ON A 16BIT
RECORDING>
<CHECK TAPE’S ERASE
PROTECTION SWITCH>
A. DUB ERROR!
LENS CAP
