LX-P1010ZU/ZE
1.7. How to replace the lithium battery
7
Inserting the battery
Insert the lithium battery which is supplied with the remote
control unit, making sure that the polarities are correct.
WARNING:
Replace battery with CR2025 only. Use of another battery may present
a risk of fire or explosion.
Caution: Battery may explode if mistreated. Dispose of used battery
promptly. Keep away from children. Do not recharge, disassemble or
dispose of in fire.
1.5. Cleaning the Projection Lens
Use lens cleaning paper and cleaner available at your local camera
shop, etc.Dampen the cleaning paper with cleaner and gently wipe
the surface of the lens from the center outward to remove dust as
shown in Fig. 1-5-1.
•
Installation
1. Insert the end of the Flexible Cable into the Trap Connector.
2. Without twisting the Cable, press the Locking Tab in into its
locked positions.
3. Gently and slightly pull up on the Cable to confirm if it is
installed firmly.
Note:
•
Do not drop the remote control unit.
•
Keep the remote control unit away from liquids.
•
Remove the battery if not using the remote control unit for long
periods.
3. Insert the battery holder.
2. Insert the battery into the battery holder so that the + side
is facing upward.
1. While pushing the battery holder tab to the right, pull out the
battery holder.
Note:
Do not use excessive force when cleaning the lens.
1.6. Connection of the Flexible Cables
to Trap Connector
(Removal and Installation of Flexible Cable)
•
Removal
(Type A)
1. On the Trap Connector, swing the Locking Tab to release the
Trap portion of the Connector. Then pull Flexible Cable out
to remove as shown in Fig. 1-6-1.
(Type B)
1. On the Trap Connector, swing both ends of the Locking Tab
to release the Trap portion of the Connector. Then pull Flexible
Cable out to remove as shown in Fig. 1-6-1.
Fig. 1-5-1
Fig. 1-6-1
Fig No.
No. of Pins
PWB
Type
P3501
30Pin
Main PWB
A
P3502
30Pin
Main PWB
B
P3503
30Pin
Main PWB
A
P2003
18Pin
Main PWB
B
(PA014) 4
