14
3
Initial Setup
Turning the TV On for the First Time
1. Connect one end of the RF coaxial cable
to the aerial socket on the wall and
the other end of the cable to the ANT
socket on the back of your TV.
2. Plug the TV into a mains socket and switch on at the mains.
3. In standby mode, press the button on the remote control to turn the TV on. The LED indicator will flash for a few seconds
then the TV will switch on.
Do not connect the TV to the mains
supply until you have completed all
the connections.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the
mains power. To completely disconnect the mains power, please remove the mains plug from the mains socket.
Chapter
3
4. The first time you turn the TV on, it will go straight
into the First Time Installation menu. Please ensure
the aerial is plugged in.
Press the
buttons to highlight your language
then press OK.
5. Press the buttons to select your country.
6. Press the button to highlight Scan Encrypted (pay-
per-view) Channel, then press the buttons to
select On or Off.
Select Favorite Network Type
In this section you can tell your TV what to tune in.
Digital Aerial is TV through your aerial this is automatically selected.
Cable is if you have cable wired directly into your TV NOT through a set top box.
Analogue is for analogue devices that you may have connected to your TV e.g. a video recorder.
None select this if you don't want to tune in any channels, this could be because you receive your TV via a set top box that you
have connected via HDMI.
7. Press the button to highlight Select favourite
network type, then press the buttons to select
Digital Aerial, Digital Cable, Analogue or None.
Confirm these settings by pressing OK.
HDMI3
HDMI 2
(ARC)
LAN
ANT
.
VGA
Optic.OUT
SPDIF
RF coaxial cable
(not included)
JVC 40' LED Smart 4K HDR TV LT-40C880 Manual.indd 14
04/05/2018 10:22
