JVC KW-M25BT, Быстрый старт

Страница: 11 / 116

11 English |
Installation
Continued on the next page...
them to any metal part in the car.
• When only two speakers are being connected to
the system, connect the connectors either to both
the front output terminals or to both the rear output
terminals (do not mix front and rear). For example,
if you connect the
¢
connector of the left speaker
to a front output terminal, do not connect the
¤
connector to a rear output terminal.
• After the unit is installed, check whether the brake
lamps, blinkers, wipers, etc. on the car are working
properly.
• Do not press hard on the panel surface when installing
the unit to the vehicle. Otherwise scars, damage, or
failure may result.
• Reception may drop if there are metal objects near
the Bluetooth antenna.
Bluetooth antenna unit
Ñ
Supplied accessories for installation
1
x1
2
x2
3
x1
4
(3 m)
x1
5
(2 m)
x1
Ñ
Installation procedure
1) To prevent a short circuit, remove the key from
the ignition and disconnect the
¤
terminal of the
battery.
2) Make the proper input and output wire connections
for each unit.
3) Connect the wire on the wiring harness.
4) Take Connector B on the wiring harness and connect
it to the speaker connector in your vehicle.
5) Take Connector A on the wiring harness and connect
it to the external power connector on your vehicle.
6) Connect the wiring harness connector to the unit.
7) Install the unit in your car.
8) Reconnect the
¤
terminal of the battery.
9) Press the reset button.
Installing the unit
Ñ
Non-Japanese cars
Bend the tabs of the
mounting sleeve with
a screwdriver or similar
utensil and attach it in
place.
✎
NOTE
• Make sure that the unit is installed securely in place. If
the unit is unstable, it may malfunction (eg, the sound
may skip).
Ñ
Trim plate
1) Attach accessory
1
to the unit.
1
Ñ
Microphone unit
1) Check the installation position of the microphone
(accessory
4
).
2) Clean the installation surface.
3) Remove the separator of the microphone (accessory
4
), and stick the microphone to the place shown
below.
4) Wire the microphone cable up to the unit with it
secured at several positions using tape or other
desired method.
5) Adjust the direction of the microphone (accessory
4
)
to the driver.
!B5K-0670-00_KWM_K_QSG.indb 11 2019/02/15 11:00