JVC KV-M705, Руководство по обслуживанию

Страница: 8 / 47

1-8 (No.MA209)
3.1.6 Removing the monitor board
(See Fig.14)
• Prior to performing the following procedures, remove the front
assembly, top drive unit, LCD assembly, display rear cover
and display back panel.
(1) From the back side of the LCD assembly, remove the three
screws J attaching the monitor board to the LCD assembly.
(2) Disconnect the wires from the connectors ( CN791 , CN851 )
on the monitor board.
(3) Take out the monitor board with the insulator.
Reference:
• When attaching the screw J , attach it with the ground spring.
• After connecting the wire to the connector CN851 , fix it with
the new tape.
Fig.14
3.1.7 Removing the LCD module
(See Fig.15)
• Prior to performing the following procedures, remove the front
assembly, top drive unit, LCD assembly, display rear cover,
display back panel and monitor board.
(1) From the back side of the LCD assembly, release the four
section d attaching the LCD module while lifting up the LCD
module.
(2) Take out the LCD module from the LCD assembly.
Reference:
When releasing the LCD module, take care not to break it.
Fig.15
3.1.8 Removing the rear bracket
(See Fig.16)
• Prior to performing the following procedures, remove the front
assembly and top drive unit.
(1) From the back side of the bottom case assembly, remove
the six screws K attaching the rear bracket to the bottom
case assembly.
(2) Take out the rear bracket from the bottom case assembly.
Fig.16
J
J
Monitor board
CN791
Ground spring
Tape CN851
LCD module Section d
K
Rear bracket