3 – EN
Audio amplifier section
Maximum Power Output:
Front/Rear:
50 W per channel
Continuous Power Output (RMS):
Front/Rear:
19 W per channel into 4 Ω,
40 Hz to 20 000 Hz at no more
than 0.8% total harmonic
distortion.
Load Impedance:
4 Ω (4 Ω to 8 Ω allowance)
Tone Control Range:
Bass:
±12 dB at 100 Hz
Treble:
±12 dB at 10 kHz
Frequency Response:
40 Hz to 20 000 Hz
Signal-to-Noise Ratio:
70 dB
Other Terminal:
AUX (auxiliary) input jack
Tuner section
Frequency Range:
FM1/2: 87.5 MHz to 108.0 MHz
FM3:
65.00 MHz to 74.00 MHz
AM:
MV: 522 kHz to 1 620 kHz
LW: 144 kHz to 279 kHz
[FM Tuner]
Usable Sensitivity: 11.3 dBf (1.0 μV/75 Ω)
50 dB Quieting Sensitivity: 16.3 dBf (1.8 μV/75 Ω)
Alternate Channel Selectivity (400 kHz): 65 dB
Frequency Response: 40 Hz to 15 000 Hz
Stereo Separation: 30 dB
[MW Tuner]
Sensitivity/Selectivity: 20 μV/35 dB
[MW Tuner]
Sensitivity: 50 μV
SPECIFICATIONS
INSTRUCTIONS
CD player section
Type:
Compact disc player
Signal Detection System: Non-contact optical pickup
(semiconductor laser)
Number of channels:
2 channels (stereo)
Frequency Response:
5 Hz to 20 000 Hz
Dynamic Range:
93 dB
Signal-to-Noise Ratio:
98 dB
Wow and Flutter:
Less than measurable limit
MP3 Decoding Format: (MPEG1/2 Audio Layer 3)
Max. Bit Rate: 320 kbps
WMA (Windows Media
®
Audio) Decoding Format:
Max. Bit Rate: 192 kbps
General
Power Requirement:
Operating Voltage: DC 14.4 V
(11 V to 16 V allowance)
Grounding System:
Negative ground
Allowable Operating Temperature: 0°C to +40°C
Dimensions (W × H × D):
Installation Size (approx.):
182 mm × 52 mm × 160 mm
Panel Size (approx.):
188 mm × 58 mm × 13 mm
Mass (approx.):
1.3 k
g
(excluding accessories)
Design and specifications are subject to change without
notice.
Sound adjustments
Indication (For)
BAS
TRE LOUD
USER
(Flat sound)
00
00
OFF
ROCK
(Rock or disco music)
+03
+01ON
CLASSIC
(Classical music)
+01–02
OFF
POPS
(Light music)
+04
+01OFF
HIP HOP
(Funk or rap music)
+02
00
ON
JAZZ
(Jazz music)
+02
+03
OFF
BAS: Bass; TRE: Treble; LOUD: (loudness)
Adjusting the sound
Preset values
SETTINGS
BAS
*
1
(bass)
Adjust the bass.
–06 to +06
TRE
*
1
(treble)
Adjust the treble.
–06 to +06
FAD
*
2
(fader)
Adjust the front and rear speaker
balance.
R06 to F06
BAL
(balance)
Adjust the left and right speaker balance.
L06 to R06
LOUD
*
1
(loudness)
Boost low and high frequencies to
produce a well-balanced sound at a low
volume level.
LOUD ON or
LOUD OFF
VOL
(volume)
Adjust the volume.
00 to 50
(or 00 to 30)
*
3
*
1
When you adjust the bass, treble, or loudness, the
adjustment you have made is stored for the currently
selected sound mode (c-EQ) including “USER.”
*
2
If you are using a two-speaker system, set the fader level
to “00.”
*
3
Depending on the amplifier gain control setting.
Symptoms
Remedies/Causes
General
• Sound cannot be heard from the speakers.
• Adjust the volume to the optimum level.
• Check the cords and connections.
• This unit does not work at all.
Reset the unit.
FM/AM
• SSM automatic presetting does not work.
Store stations manually.
• Static noise while listening to the radio.
Connect the aerial firmly.
Disc playback
• Disc cannot be played back.
Insert the disc correctly.
• CD-R/CD-RW cannot be played back.
• Tracks on the CD-R/CD-RW cannot be
skipped.
• Insert a finalized CD-R/CD-RW.
• Finalize the CD-R/CD-RW with the component which you used
for recording.
• Disc can be neither played back nor ejected. • Unlock the disc.
• Eject the disc forcibly.
• Disc sound is sometimes interrupted.
• Stop playback while driving on rough roads.
• Change the disc.
• Check the cords and connections.
• “NO DISC” appears on the display.
• “PLEASE” and “EJECT” appear alternately
on the display.
Insert a playable disc into the loading slot.
MP3/WMA playback
• Disc cannot be played back.
• Use a disc with MP3/WMA tracks recorded in a format compliant
with ISO 9660 Level 1, Level 2, Romeo, or Joliet.
• Add the extension code <.mp3> or <.wma> to the file names.
• Noise is generated.
Skip to another track or change the disc. (Do not add the extension
code <.mp3> or <.wma> to non-MP3 or WMA tracks.)
• A longer readout time is required
(“READING” keeps flashing on the display).
Do not use too many hierarchical levels and folders.
• Tracks are not played back in the order you
have intended.
Playback order is determined when the files are recorded.
• The elapsed playing time is not correct.
This sometimes occurs during playback. This is caused by how the
tracks are recorded on the disc.
• The correct characters are not displayed
(e.g. album name).
This unit can only display alphabets (upper case), numbers, and a
limited number of symbols.
• Microsoft and Windows Media are either registered trademarks or trademarks of Microsoft Corporation in the United
States and/or other countries.
TROUBLESHOOTING
General settings—PSM
Indication
Item
( : Initial)
Setting
DEMO
•
DEMO ON
•
DEMO OFF
: The display demonstration will be activated automatically if no
operation is done for about 20 seconds.
: Cancels.
CLK DISP
*
1
•
ON
•
OFF
: The clock time is shown on the display at all times when the power is
turned off.
: Cancels; pressing DISP will show the clock time for about 5 seconds
when the power is turned off.
CLOCK H
(Hour)
0
–
23
(
1
–
12
)
: [Initial: 0 (0:00)]
CLOCK M
(Minute)
00
–
59
: [Initial: 00 (0:00)]
24H/12H
•
24H
•
12H
: See “Basic settings.”
CLK ADJ
*
2
•
AUTO
•
OFF
: The built-in clock is automatically adjusted using the CT (clock time)
data in the RDS signal.
: Cancels.
AF-REG
*
2
•
AF
•
AF REG
•
OFF
: When the currently received signals become weak, the unit switches
to another station (the programme may differ from the one currently
received).
• The AF indicator lights up.
: When the currently received signals become weak, the unit switches to
another station broadcasting the same programme.
• The AF and REG indicators light up.
: Cancels.
PTY-STBY
*
2
OFF
, PTY codes
Activates PTY Standby Reception with one of the PTY codes.
TA VOL
*
2
VOL 00
–
VOL 50
(or
VOL 00
–
VOL 30
)
*
3
[Initial: VOL 15]
P-SEARCH
*
2
•
ON
•
OFF
: Activates Programme Search.
: Cancels.
DIMMER
•
ON
•
OFF
: Dims the display and button illumination.
: Cancels.
TEL
•
MUTING 1/
MUTING 2
•
OFF
: Select either one which mutes the sounds while using a cellular phone.
: Cancels.
SCROLL
*
4
•
ONCE
•
AUTO
•
OFF
: Scrolls the displayed information once.
: Repeats scrolling (at 5-second intervals).
: Cancels.
• Pressing DISP for more than one second can scroll the display
regardless of the setting.
AUX ADJ
A.ADJ 00
–
A.ADJ 05
: Adjust the auxiliary input level to avoid the sudden increase of the
output level when changing the source from external component
connected to the AUX input jack on the control panel.
TAG DISP
•
TAG ON
•
TAG OFF
: Shows the tag while playing MP3/WMA tracks.
: Cancels.
AMP GAIN
•
LOW PWR
•
HIGH PWR
: VOL 00 – VOL 30 (Select if the maximum power of each speaker is less
than 50 W to prevent the speaker from being damaged.)
: VOL 00 – VOL 50
IF BAND
•
AUTO
•
WIDE
: Increases the tuner selectivity to reduce interference noise between
close stations. (The stereo effect may be lost.)
: Subject to the interference noise from adjacent stations, but the sound
quality will not be degraded and the stereo effect will remain.
*
1
If the power supply is not interrupted by turning off the ignition key of your car, it is recommended that you select “OFF” to
save the car’s battery.
*
2
Only for FM RDS stations.
*
3
Depends on the amplifier gain control.
*
4
Some characters or symbols will not be shown correctly (or will be blanked) on the display.
Select an item.
Adjust.
Finish.
Enter PSM menu.
EN_KD-G347[EE]_f.indd 3
EN_KD-G347[EE]_f.indd 3
9/10/07 10:03:15 AM
9/10/07 10:03:15 AM