1-26 (No.MA248)
After replacing the pickup, set the unit in the service mode to display a jitter value on the LCD. Confirm that the jitter value measured
with a jitter meter is within 12% of the jitter value displayed on the LCD. If it is within 12%, then adjustment is not necessary. Please
note that a jitter value displayed on the LCD is hex data. Refer to the corresponding decimal notation value using the Jitter Conversion
Table and confirm it with the measured value.
Fix the screws "
a
", "
b
" and "
c
" with screw lock paint.
If the measured jitter value is outside the 12% tolerance range, perform the following adjustments.
(1) Set the unit to the service mode and display a jitter value (hex data) on the LCD.
(2) Turn each of the screws
a
,
b
and
c
, by a half-turn per step, in the direction that reduces the jitter value in order to minimize it.
(Do not turn a screw more than a half turn at a time, but adjust the screw in the cycle of same level turn by pair of
b+c
→
pair of
a+b
.)
(3) After completing the adjustment, secure the screws with screw lock paint.
Jitter value adjustment procedure (Pickup horizontal level adjustment relative to the DVD recording surface)
(For the adjustment tool use a 3 mm wrench and not a screwdriver, this procedure will make the adjustment easier.
b
c
a
3 mm wrench
Содержание KD-DV4200J
Страница 19: ... No MA248 1 19 Fig 8 Fig 9 Clamper unit Clamper spring Notch g Clamper unit ...
Страница 37: ... No MA248 1 37 ...