KD-G324/KD-G323
Installation/Connection Manual
GET0343-002A
[UI]
1005DTSMDTJEIN
EN
This unit is designed to operate on
12 V DC, NEGATIVE ground electrical systems
. If your vehicle does
not have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers.
1
© 2005 Victor Company of Japan, Limited
When installing the unit without
using the sleeve
In a Toyota car for example, first remove the car
radio and install the unit in its place.
When using the optional stay
Note:
When installing the unit on the mounting
bracket, make sure to use the 8 mm-long screws.
If longer screws are used, they could damage the
unit.
*
Not supplied
for this unit.
Flat type screws
(M5
×
8 mm)
*
Flat type screws (M5
×
8 mm)
*
Screw (option)
Stay (option)
Fire wall
Dashboard
Install the unit at an angle of less than 30˚.
Removing the unit
Before removing the unit, release the rear section.
Insert the two handles, then pull them as
illustrated so that the unit can be removed.
J
Handles
F
Washer (ø5)
G
Lock nut (M5)
H
Mounting bolt (M5
×
20 mm)
I
Rubber cushion
A
/
B
Hard case/Control panel
C
Sleeve
D
Trim plate
E
Power cord
Parts list for installation and connection
The following parts are provided for this unit. After checking them, please set them correctly.
Heat sink
WARNINGS
To prevent short circuits, we recommend that you disconnect the battery’s negative terminal and make all
electrical connections before installing the unit.
•
Be sure to ground this unit to the car’s chassis again after installation.
Notes:
• Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC car audio
dealer.
• It is recommended to connect to the speakers with maximum power of more than 50 W (both at
the rear and at the front, with an impedance of
4
Ω
to 8
Ω
). If the maximum power is less than
50 W, change “AMP GAIN” setting to prevent the speakers from being damaged (see page 11 of the
INSTRUCTIONS).
• To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape.
• The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.
Do the required electrical
connections.
*
1
When you stand the unit,
be careful not to damage
the fuse on the rear.
Bend the appropriate tabs to hold
the sleeve firmly in place.
INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require information
regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
• If you are not sure how to install this unit correctly, have it installed by a qualified technician.
PRECAUTIONS on power supply and speaker connections:
•
DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit
will be seriously damaged.
• BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in
your car.
Bracket
*
Bracket
*
Instal1-2_KD-G324_3[UI]f.indd 1
Instal1-2_KD-G324_3[UI]f.indd 1
10/14/05 11:17:49 AM
10/14/05 11:17:49 AM