JVC KA-MR100G, Инструкция по эксплуатации

Страница: 17 / 20

14
Other s
When warning messages appear on the LCD panel, take the
following actions.
Battery and Signal Error Me ss age s
An error message appears at the first line of the LCD panel
display when the battery is weak or when there is an input
signal error. When an error message appears, take the
following actions.
(*1) Appears during the recording or stop mode.
Card Error Me ss age s
When an SxS memory card incompatible with the memory
recorder is detected, an
A ERROR CARD! B message and a
message indicating the cause of the card error will appear
alternately at the first line of the LCD panel display. (For
approximately two seconds) When an error message
appears, take the following actions.
Card error message appears when the following operations
are performed.
●
When an SxS memory card is inserted
●
When power is turned on with an SxS memory card
inserted
䡵
When in the s top, s tandby or s till mode
Status screen (stop or standby)
Clip selection screen (still)
䡵
When in the menu s creen di s play
Warning Me ss age s
Message Description
CLOCK
SETUP
MENU Appears when the clock is not set.
Action: Set the clock when the [CLOCK1]
setting screen appears.
WRITE
PROTECT! Appears when the write-protect switch of
the SxS memory card is set to the “WP”
end.
Action: Set the write-protect switch to
A Off B
before recording or deleting a clip.
CARD FULL! Appears when there is no more space left
on the SxS memory card.
Action: Take any of the following actions.
●
Use an SxS memory card with sufficient
space.
●
Delete unwanted clips or format the card
to create space.
OPERATION
LOCK ! Appears when buttons other than the
[MENU] button is pressed with the
[OPERATION] menu set to
A LOCK B .
Action: Change the [OPERATION] menu
setting to
A UNLOCK B .
Error Me ss age s
Message Description
BAT.
ALARM ! Appears when the remaining battery level
is insufficient.
Action: Charge the battery.
SHUT
DOWN ! Appears immediately before the battery
runs out completely. The memory recorder
will shut down a few seconds after the
message is displayed.
Action: Charge the battery.
NO SIGNAL !
(*1) Appears when there is no signal input.
Action: Check the connection of the
IEEE1394 cable and the camcorder
settings.
Other
SIGNAL (*1) Appears when the format of input signals is
different from that of the memory recorder.
Action: Make sure that the memory
recorder settings are consistent with those
of the camcorder. (
A
Page 9)
Warning Messages
WRITE
PROTECT!
Message Description
NO
SUPPORT! Appears when a media not supported by
the memory recorder is inserted.
Action: Replace it with a recommended
SxS memory card.
FORMAT! Appears when the card has already been
formatted by another device.
Action: Execute
A FORMAT B using this
memory recorder.
“Menu screen’s [MEDIA]->[FORMAT]
settings” (
A
Page 13)
CARD
CHANGE Appears when errors are found in the clip.
Action: Execute
A
RESTORE
B
or
A
FORMAT
B
using this memory recorder. If
doing so does not eliminate the error, it
may be due to malfunction of the SxS
memory card. Replace the SxS memory
card.
RESTORE ! Appears when the clip may be damaged.
Action: Execute
A RESTORE B using this
memory recorder.
<LCD Panel>
<LCD Panel>
<LCD Panel>
KA-MR100G_EN.book Page 14 Thursday, February 5, 2009 5:28 PM