7
ENGLISH
7
IF-CF01RBG (Component/RGB Active Through Card)
Front view
Label
Rear view
1
Audio signal input (INPUT)/output (ACTIVE THROUGH OUT) terminals
Accepts/outputs analog audio signals.
NOTE:
• These terminals cannot be used for both RGB and component signals at the same time.
2
Component/RGB signal input (INPUT)/output (ACTIVE THROUGH OUT)
terminals
Accepts/outputs component (color difference) or RGB signals.
Select input by using the button on the monitor.
Select component signal:
INPUT C
Select RGB signal:
INPUT D
3
Synchronized signal input (INPUT)/output (ACTIVE THROUGH OUT) terminals
When RGB signal is selected, accepts the vertical, horizontal or composite
synchronized signals.
When using these terminals, “SYNC TERM.” can be switched between “HIGH” and
“LOW.” Refer to your monitor instruction manual for more information.
• The synchronized signals are output only when synchronized signals of TTL level are input.
4
Label (see page 5)
1
On the rear panel:
Place the INPUT label to SLOT-1 and the ACTIVE THROUGH
OUT label to SLOT-2.
2
On the remote control:
When the input signal type for input B is fixed (RGB,
COMPO., or DVI), place the corresponding label on the printing of the input select
buttons A and B.
3
On the remote control:
Place the label on the printing of the input select buttons (C – F).
5
Connection terminal (on the rear side)
Attach to the connection terminal in the slot of your monitor.
NOTE:
• The wired output is protected against signal deterioration when multiple monitors are connected.
02_EN_LCT1973-01A-3b.p65
05.10.25, 21:11
7
