– 24 –
4
Set the on-time you want the
unit to turn on at.
1) Turn
4
/
¢
to set the hour, then
press SET/DISPLAY.
“SET” appears for 1 second.
2) Turn
4
/
¢
to set the minute,
then press SET/DISPLAY.
“SET” appears for 1 second, then
the unit enters off-time setting mode.
5
Set the off-time you want the unit to turn off
(on standby) at.
1) Turn
4
/
¢
to set the hour, then press
SET/DISPLAY.
“SET” appears for 1 second.
2) Turn
4
/
¢
to set the minute, then press
SET/DISPLAY.
“SET” appears for 1 second, then the unit enters preset
station selecting mode.
6
Select the preset station.
1) Turn
4
/
¢
to select the band (“TUNER FM” or
“TUNER AM”), then press SET/DISPLAY.
“SET” appears for 1 second.
2) Turn
4
/
¢
to select a preset channel number,
then press SET/DISPLAY.
The REC (Recording Timer) indicator stops flashing
and remains lit. “OK
” appears on the display for
2 second.
The settings you have done are shown on the display
in sequence for your confirmation.
7
Press
to turn off the unit (on
standby) if necessary.
• If you want to listen to another source while recording
Press REC START/STOP or
7
to stop recording. Without
stopping it, you cannot change the source.
• Even if you unplug the AC power cord or if a power failure
occurs
Once you set the timer, the timer setting may remain stored in
memory in a few days. In this case, check whether the timer
setting still remains or not.
DAILY
Canceled
TIMER
(Daily Timer setting)
TIMER
(Recording Timer setting)
REC
Clock
setting
(The hour digits start flashing.)
Using Recording Timer
With Recording Timer, you can make a tape of a radio
broadcast automatically.
You can set the timer whether the unit is on or off; however, if
Ecology Mode is activated, you cannot set the clock while the
unit is off.
How Recording Timer actually works
The unit automatically turns on, tunes in to the specified
station, sets the volume level to “VOLUME MIN,” and starts
recording when the on-time comes (“REC” and the REC
(Recording Timer) indicator flash just before the on-time, and
the REC (Recording Timer) indicator continues flashing
while the timer is operating). Then, when the off-time comes
(“REC OFF” appears just before the off-time), the unit
automatically turns off (on standby).
The timer setting remains in memory until you change it.
• There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step
2
again.
• To correct a mis-entry while setting the timer, press
CANCEL/DEMO.
On the unit ONLY:
1
Insert a recordable cassette in with the expose
part of the tape down.
2
Press CLOCK/TIMER
repeatedly until “REC”
appears on the display.
(Timer) indicator lights up and the REC (Recording
Timer) indicator also starts flashing on the display.
• Each time you press the button, the timer setting modes
change as follows:
3
Press CLOCK/TIMER again.
“TIMER” appears for 2 seconds, then the
unit enters on-time setting mode.
CLOCK
/ TIMER
CLOCK
/ TIMER
PRESET
SET /
DISPLAY
R E C
Continued
R E C
R E C
EN19-25.HX-Z1[J]f.pm6
2/18/02, 7:21 PM
24
